In Houdini, some tools use the mouse wheel to change the parameters of nodes. For example, after using the PolyExtrude tool, by scrolling the mouse wheel you can increase the number of divisions. Modeler tries to be comfortable not only when modeling with mouse, but also tablet pen users. Therefore, a universal tool was invented to help quickly change the node. Parm Slider is similar to the mouse wheel in other programs, but instead of scrolling the wheel, you need to drag the mouse left or right. Moving the mouse increases or decreases the value of the parameter. Also Parm Slider can change checkbox type parameters or even change a few parameters by quickly pressing and releasing the hotkey.
In the EdgeLoop state, you can tap the Parm Slider one or more times before inserting to make the loop take the shape of a loop on the opposite side.
Node | Drag Parameter | Tap Parameter |
---|---|---|
QPrimitive | Uniform Resolution | |
Extrude | Divisions | Extrusion Mode: |
Primitive/Edge Normal → Point Normal | ||
Thickness | Divisions | Keep |
Bevel | Divisions | Bevel Shape: Round → Crease |
Bevel Pro | Divisions | |
Bridge | Divisions | Curved Mode |
Connect | Divisions | |
Edge Flow | Curvature | |
Topo Stroke | Snap Patch | |
Fill Quads | Fill Mode | |
Symmetrize | Fix Seam | Remove Seam |
Detach | Offset | |
Clean Edges | Min Edge Angle | |
LoopCut | Number of Loops | |
Relax | Pin Boundary | |
VDB Remesh | VDB Quality | |
Edges to Curves | Keep Input | |
Group Hard Edges | Min Angle |